FORD RANGER STEDI RALLY BAR LIGHT MOUNTING BRACKET

The nudge bar re-imagined.

To suit Ford Ranger PX2, PX3, Raptor, and Everest vehicles. DOES NOT SUIT NEXT-GEN MODELS

This simple bracket for your Ford Ranger is the perfect solution to mount a set of driving lights without compromising your Ranger, Everest, or Raptor's original look. It was designed so that it can be installed with no modifications necessary to the vehicle, and it's much lighter than a nudge bar or bull bar.

The STEDI Rally Bar is designed for a seamless fully reversible and non-intrusive install (grill dependent). The inner support system is connected to the existing fasteners behind the grill, without the need for any holes. Once installed, you can expect a higher mounting position than the factory counterpart and the optimal setup for a killer lighting combination. With slick styling and the perfect compatibility for the STEDI product range, our Rally Bar will seamlessly uphold your expectations while loudly showcasing the quintessential quality of STEDI.

The STEDI Rally Bar is a perfect match for our 60-66mm Hex Brackets. The Hex is designed to reduce excessive mounting equipment, and when combined with the Rally Bar, provides the perfect solution for hosting your ideal light combination.

The STEDI Rally Bar has been designed to comply with all relevant ADR's.

The Rally bar is not designed to offer protection to your vehicle and should not be considered for this purpose. The Rally bar is designed as a platform to allow the fitting of driving lights without the need for a frontal protection system (Bullbar). The Rally bar has been designed to comply with all regulations as set out in ADR 69/ and ADR 73/.

The STEDI Rally Bar is a perfect match for our 60-66mm Hex Brackets. The Hex is designed to reduce excessive mounting equipment, and when combined with the Rally Bar, provides the perfect solution for hosting your ideal light combination.

IN THE BOX:

• 1 x LHS Vertical Support
• 1 x RHS Vertical Support
• 1 x Lower Radiator Support Bracket
• 1 x Upper Boomerang Support Bracket
• 1 x LHS Projection bracket
• 1 x RHS Projection bracket
• 1 x 60mm Rally bar tube
• 4 x M8 Hex Head 20mm Bolts
• 14 x M8 Allen Head 20mm Bolts
• 4 x M6 Allen Head 18mm Bolts
• 36 x M8 Flat Washers
• 18 x M8 Nyloc Nuts
• 4 x M6 Nyloc Nuts